Ceiling Projection

Post Reply
tornado
Posts: 5
Joined: Fri May 03, 2019 4:08 pm
Contact:

Tue May 07, 2019 2:51 pm

Hello Everyone
Is there a tutorial for a ceiling projection with to procectors (x2,y1)?
If I make a ceiling projection, i think i need to turn the screen upside down, to get the projectors to map correctly (upside down) to the screen.
But if I do this, eather the projectors are right and left swapped, or the testpattern is from outside to inside, there must be something I am doing wrong.

Best Regards

Zeno
 
User avatar
Michael Eckschlager
Posts: 81
Joined: Thu May 11, 2017 7:09 am
Contact:

Wed May 08, 2019 8:34 am

Hi Zeno,

well, you are closer to the solution than you might think.
If you see your testpattern/content swapped (rear projection) then the reason is that the screen is rotated in the wrong direction.
So in the "Screens" tab, choose your screen and check the "Rotation" field.
If the rotation value has a minus position then change it to a positive one (-90 to 90).

Unfortunately there's a small bug in this situation so you can't choose exactly 90 degrees. But you can insert the value 89.99 and then you should get the right image on your output!
Pixera Ceiling.png
You do not have the required permissions to view the files attached to this post.
Best Regards from Austria
Michael Eckschlager
_____________________________________________________
AV STUMPFL GMBH | Michael Eckschlager | Technical Support
Mitterweg 46 | A-4702 Wallern | Tel +43(7249)42811
support@avstumpfl.com | www.AVstumpfl.com
Post Reply