AV Stumpfl technical forum

i'm facing something new with Avio.
On a simple configuration Wings vioso + Wings touch, if i set avio webserver port to 16001, first it works.
then, if i restart my computer, and try to connect again with my ipad, if i go on 192...:16001 i land on the AVIO page. and if i type 192....:16002, i land on my touch project.

Restart again, and 16001 works, and 16002 is Avio instead of 16000.

If, i set webserver port to 16002 in the settings, same problem each time i restart.

if i set webserver port to 16003 or different, i don't have any problems.
First time seeing this, what's happening ?

Hi EtiennePrestans!

AVIO uses Ports 16000, 16001, ... as the default. The Program which is started first gets the first Port! The AVIO Service will normally be available on a Port 16000 after a reboot. And Wings Touch on 16001. All AVIO nodes receive their own Port address. If, for example, the Service is started (16000) and then the Manager (16001), a new Touch Project is initially given the address 16002.

After a restart, the Port address is assigned to 16001. It can help to set the Port to 16002. But only, if not before another Program saves the Port for itself.

Therefore, it is recommended to select a Port outside the Range 16000 - 16010.

Mit freundlichen Grüßen aus Wallern | Best Regards from Austria
Christoph Koch
_____________________________________________________
AV STUMPFL GMBH | Christoph Koch | Project Team
Mitterweg 46 | A-4702 Wallern | Tel +43(7249)42811
c.koch@avstumpfl.com | www.AVstumpfl.com

Understood,
that is good to know.

Therefore, in avio service you should change the default webserver adress for Touch project.

Hi

Thanks for the input! I have forwarded the suggestion to the developers.

Mit freundlichen Grüßen aus Wallern | Best Regards from Austria
Christoph Koch
_____________________________________________________
AV STUMPFL GMBH | Christoph Koch | Project Team
Mitterweg 46 | A-4702 Wallern | Tel +43(7249)42811
c.koch@avstumpfl.com | www.AVstumpfl.com