How to synchonize your outputs

The World of our LITE, PRO, STAGE and RAW media servers
Post Reply
User avatar
Michael Eckschlager
Posts: 92
Joined: Thu May 11, 2017 7:09 am
Contact:

Wed May 31, 2017 9:06 am

In this tutorial we explain you how to synchronize the outputs on your Wings Engine.
Please be aware that this tutorial only applies to one engine!
  1. 1.) If the presentation is currently running, leave the presentation mode (in Wings RX terminate the render engine).
    Click on Settings on your GUI.
    GUI.png
  • 2: Open the Nvidia Control Center.
    Open Nvidia Control Center.png
  • 3: Go to "Synchronize displays".
    Then click "On this system" and choose the display with which the other displays should synchronize.
    After this step, choose your displays you want to have synchronized.
    Attention: You can only choose displays which have the same Resolution and Refresh Rate as the display you have choosen a step before!
    Click "Apply"
    Synchronization Settings.png
  • 4: To confirm click "Yes".
    Click Yes.png
  • 5: Now all choosen displays are successfully synchronized to one display.
    On this system applied.png
You do not have the required permissions to view the files attached to this post.
Best Regards from Austria
Michael Eckschlager
_____________________________________________________
AV STUMPFL GMBH | Michael Eckschlager | Technical Support
Mitterweg 46 | A-4702 Wallern | Tel +43(7249)42811
support@avstumpfl.com | www.AVstumpfl.com
Post Reply